|
|
Post by J on Oct 13, 2004 3:13:13 GMT 8
does anyone knows how to insert USD THRONE SOUL onto SALOMON skates..Do i have to grind away the whole bottom and the side of the boot totally flat?  |
|
|
|
Post by sukeats on Oct 13, 2004 9:19:39 GMT 8
no - i dont think so.
im assuming you're talkin bout the Throne UFS soul plates.
|
|
|
|
Post by George on Oct 13, 2004 23:37:05 GMT 8
i cant remember totally how i did it, but there are bits off the boot underneathe that you need to grind flat.
also, if i was you i'd drill holes in the bottom of the plates and put in rivets. because the souls get bendy. ask bal.
|
|
|
|
Post by coollen on Oct 25, 2004 12:39:12 GMT 8
Coollen technics: First i took off my frames and wings, then i wear on my SALOMON boots, and i use my scooter, (not recommended for those who doesnt know how to surf with ya bike) Better check out 'BIKER BOYS' the movie and learn some bike surfing technics! while my scooter was moving, i press both of my foot down to the tar road, so it looks like a boot bottom cess slides... after a few cess sliding,the bottom of my boots become flat! (warning: dont slide it too much or else you will have to buy a new boot!) and thats all i did to flatten my boots. RESULTS:  |
|
|
|
Post by iglue on Oct 25, 2004 12:46:22 GMT 8
haha no need for a bench grinder...
|
|
|
|
Post by George on Oct 25, 2004 22:50:03 GMT 8
Coollen technics: First i took off my frames and wings, then i wear on my SALOMON boots, and i use my scooter, (not recommended for those who doesnt know how to surf with ya bike) Better check out 'BIKER BOYS' the movie and learn some bike surfing technics! while my scooter was moving, i press both of my foot down to the tar road, so it looks like a boot bottom cess slides... after a few cess sliding,the bottom of my boots become flat! (warning: dont slide it too much or else you will have to buy a new boot!) and thats all i did to flatten my boots. RESULTS: hahahahhahah fucking miss you coollen! come back home! |
|
